Electrical Connection SMA Solar Technology AG
34 SMC9-11TLRP-IEN100640 Installation Guide
4. Push the threaded joint to the thread and screw into place.
☑ The DC plug connectors are now assembled and can be connected to the inverters, as
described in section 5.5.4”Connecting the PV Generator (DC)” (page36).
☑ If the conductor is not visible in the hollow
cavity of the clamp, the cable is not in the
correct position.
• Loosen the clamping clip with the help of a
screwdriver.
• Remove cable and start again from step 1.
Result Action
To Next Page
Loading...
