SMA 10000TL - 6.5 DC Connection; 6.5.1 DC Connection Requirements

Electrical Connection SMA Solar Technology AG
38 SMC9-11TLRP-IEN100640 Installation Guide
7. Check the Electronic Solar Switch for wear, as
described in section 8.2”Checking the Electronic
Solar Switch (ESS) for Wear” (page65) and
attach it firmly.
☑ The PV generator is now connected.
You can now commission the inverter as described in section 6”Commissioning” (page55).
The following connection options are optional.
NOTICE!
Manipulating the connector in the handle can damage the Electronic Solar
Switch!
The connector inside the handle must remain movable in order to ensure proper contact.
Tightening the screw voids all warranty claims and creates a fire risk.
•Do not tighten the connector screw in the Electronic Solar Switch handle.
NOTICE!
Damage to Electronic Solar Switch!
If not plugged correctly, the Electronic Solar Switch can be damaged by high voltages.
• Connect the holder firmly on to the socket of the Electronic Solar Switch.
• Make sure that the device is securely in place.