SMA MEDIUM VOLTAGE POWER STATION 500SC-JP - Displaying the Operation Data Via Sunny Portal; Registering the Inverter in Sunny Portal; Adjusting the PV System Identifier for Sunny Portal; Deleting the Sunny Portal Buffer

8.2.2 Displaying the Operation Data via Sunny Portal
8.2.2.1 Registering the Inverter in Sunny Portal
Automatic PV system identifier
In general, you do not have to change the preset number in the field PV system identifier. SunnyPortal uses this
number to uniquely identify the PV power plant. If you have not yet registered the PV power plant in SunnyPortal,
the predefined PV system identifier will be automatically entered in SunnyPortal after the first successful data
upload. Sunny Portal sends the login data to the e-mail address you have entered in the field Operator e-mail.
After this, your PV power plant is registered in Sunny Portal.
Procedure:
1. Log into the user interface (see Section12.8.1, page177).
2. Select SunnyCentral > Settings > Data transmission.
3. Enter the name of your PV system in the field PV system name. This name will be displayed as the name of the
PV system in SunnyPortal.
4. Set the data transmission frequency (see Section8.3.2, page107).
5. Select yes in the field Use Sunny Portal.
6. If the PV system is already registered in SunnyPortal, adapt the PV system identifier in the field PV system
identifier (see Section8.2.2.2, page106).
7. Enter your e-mail address in the field Operator e-mail. Sunny Portal will send the access data to this e-mail
address.
8. Select the button [Save].
9. Select SunnyCentral > Info.
10. Select [Register] in the field Last Sunny Portal registration. The Sunny Portal password will be sent to the e-
mail address you have entered.
8.2.2.2 Adjusting the PV System Identifier for Sunny Portal
Sunny Portal identifies the inverter via the PV system identifier. In the following cases, you will need to adjust the PV
system identifier of the inverter:
• Data of the PV power plant has already been sent to Sunny Portal via another communication unit.
• The set PV system identifier of the communication unit has been reset.
• The communication unit has been replaced.
Procedure:
1. Log into Sunny Portal (www.SunnyPortal.com).
2. Select Configuration > PV system properties.
3. Copy the PV system identifier to the clipboard.
4. Log into the user interface (see Section12.8.1, page177).
5. Select SunnyCentral > Settings > Data transmission.
6. Delete the content of the PV system identifier field.
7. Paste the PV system identifier from the clipboard into the PV system identifier field.
8. Select the button [Save].
8.2.2.3 Deleting the SunnyPortal Buffer
You can delete the data on the internal ring buffer.
8 Operation
SMA Solar Technology AG
System ManualMVPS22JP-SH-en-11106