SMA MEDIUM VOLTAGE POWER STATION 500SC-JP - Attaching the Support Feet to the MV Power Station

4.6 Attaching the Support Feet to the MVPowerStation
The MVPowerStation must be installed on the support surface with six support feet. The support feet for the station
container can be found in the accessories kit in the medium-voltage switchgear compartment. The four outer support
feet can be attached to the MVPowerStation using the T-head bolts. The center support feet must be tightened. The
height of the standard support feet is adjustable (if necessary). After the mounting process of the MVPowerStation is
completed, the height of the standard support feet can no longer be adjusted.
Requirement:
☐ To attach the support feet to the MVPowerStation, you must place the station on temporary platforms (e.g. crane
support plates). The platforms must be at least 450mm high.
Figure 25: Attachment of the support feet during unloading of the MVPowerStation at the mounting location
Required mounting material (included in the scope of delivery):
☐ Six support feet for the MVPowerStation
4 Transport and Mounting
SMA Solar Technology AG
System Manual 43MVPS22JP-SH-en-11