SMA MEDIUM VOLTAGE POWER STATION 500SC-JP - Installing the AC Connection on the MV Transformer

5.5.2 Installing the AC Connection on the MV Transformer
If the medium-voltage switchgear was not ordered with the MVPowerStation, the AC cables must be connected to the
MV transformer. The AC cables must be inserted through the base plate of the medium-voltage switchgear and through
the partition to the MV transformer. It is recommended using plastic tubes without grooves in order to allow easier
insertion of the cables.
Figure 31: Cable route for connection to the MV transformer
Requirement:
☐ The AC cables must be correctly inserted and attached.
Procedure:
• Connect the AC cables to the MV transformer (see MV transformer documentation).
5 Installation
SMA Solar Technology AG
System Manual 59MVPS22JP-SH-en-11