SMA MEDIUM VOLTAGE POWER STATION 500SC-JP - Connecting the Cable in the Inverter; Connecting Optical Fibers with Subscriber Connector

5.7.2 Connecting the Cable in the Inverter
5.7.2.1 Connecting Optical Fibers with Subscriber Connector
Figure 34: Position of the splice box
Position Designation
A Splice box
Additionally required mounting material (not included in the scope of delivery):
☐ 2 subscriber connectors
Damage to optical fibers due to too tight bend radii
Excessive bending or kinking will damage the optical fibers.
• Observe the minimum permissible bend radii of the optical fibers.
Procedure:
1. Disassemble the panels (see Section12.3.1.2, page164).
2. Insert the optical fibers in the inverter (see Section12.4.3, page171).
3. Remove the splice box from the top-hat rail:
4. Open the enclosure of the splice box.
5 Installation
SMA Solar Technology AG
System Manual 65MVPS22JP-SH-en-11