SMA Solar Technology AG 2 Installation
Installation Guide SHP75-10-STP60-10-IA-xx-18 21
2Installation
2.1 Environment and Clearances
Figure 2.1 Avoid constant contact with water
Figure 2.2 Avoid direct solar irradiation
Figure 2.3 Ensure adequate air flow
Figure 2.4 Ensure adequate air flow
Figure 2.5 Mount on non-flammable surface
Figure 2.6 Mount upright on vertical surface. A backward tilt of ten
degrees is allowed.
Figure 2.7 Avoid dust and ammonia gases
INFORMATION
When selecting the installation site, ensure that the
product and warning messages on the inverter are
visible at all times. For details, refer to Section
5, page 41.
To Next Page
Loading...
