SMA SUNNY BEAM - Adjusting the Energy Meter When Switching Devices

SMA America, LLC Operation
User Manual BeamBT-eng-BUS110712 69
5. To save the device name, select the checkmark.
☑ The device name has been changed.
7.11.5 Adjusting the Energy Meter when Switching Devices
The energy meter shows the value for the total generated energy (E-total) for every inverter. If you
need to exchange in inverter in your PV system, you can set the value for the total energy of the
previous inverter on the new inverter.
1. Note down the E-total value of the previous inverter (see section 7.4 "Power and Energy
Display" (page47)).
2. Select "Settings > PV plant > Offset energy meter".
3. Select the new inverter.
4. Select "Display".
5. Enter the value of the previous inverter.
☑ The energy meter has been adjusted.
Umlauts in device names are not displayed correctly in the CSV files.