4. Insert screw anchors into the drill holes if the support surface requires them.
5. When screwing the screws in, make sure that there is at least 6 mm left between the screw
head and the support surface.
6. Hang the inverter onto the screws using the
metal brackets.
7. Tighten the screws hand-tight using a ratchet or box wrench. When doing this you can
compensate for any misalignment of the drill holes by aligning the metal brackets accordingly.
8. Ensure that the inverter is securely in place.
5Mounting
SMA Solar Technology AG
Operating ManualSB15-25-1VL-40-BE-en-1122
To Next Page
Loading...
