SMA SUNNY BOY 2000HF - Mounting the Quick Module

The communication module (Quick Module) SMA Solar Technology AG
32 SB20_25_30HF-IEN102911 Installation Guide
5.4 Mounting the Quick Module
1. Disconnect the inverter on the AC and DC sides as described in section 8”Disconnect the
Inverter from Voltage Sources” (page60).
2. Put the Quick Module into the designated holes on
the bracket.
3. Push the Quick Module upwards in the guide slot
until it clicks into place.
4. Check that the Quick Module is correctly seated.
The loops of the Quick Module and the bracket
must be positioned flush on top of each other.
☑ The Quick Module is mounted.
NOTICE!
Damage to the Quick Module due to improper installation in the inverter.
The Quick Module could be damaged when incorrectly installed in the inverter.
• Check the Quick Module for visible external damage before installation.
• Carefully install the Quick Module, as described in the following section.