3. Select PV System Selection > "My SunnyHomeManager system" in the page and
menu selection.
4. If you would like to replace a device in SunnyPortal, deactivate the old device (see
Section10.2, page96).
5. Select Device overview>Overview of new devices in the page and menu selection.
6. Select [Refresh devices]. The SunnyHome Manager then searches for new BLUETOOTH
devices within range and for new devices in the local network.
☑ After a maximum of one minute, all new devices are displayed.
✖ None or not all of the new devices are displayed?
An error has occurred.
• Eliminate the error (see Section15, page127).
7. To add a device, select in the line of the device.
8. To replace a device, select in the line of the new device.
☑ The SunnyHomeManager connects to the new device. Page 2 of the configuration
wizard opens.
✖ Page2 of the configuration wizard does not open but the error message Connection
Failed is displayed?
A password other than 1111 or other than the system password of the existing system is
set for the new SMA device.
• Temporarily change the system password of the existing system to the password of
the new SMA device (see Section14.3, page124).
9. Follow the instructions of the configuration wizard.
10.
Replacing an inverter
It can take up to 20minutes to replace an inverter using the configuration wizard.
☑ The new SMA device is displayed under Configuration > Device overview.
☑ The new device connected via Ethernet is displayed under Configuration > Load
overview and planning.
11. If you have just changed the system password of the existing system to the password of the
new SMA device, reset the old system password (see Section14.3, page124).
12. If the new device is a radio-controlled socket, configure the radio-controlled socket (see
Section9.2, page75). Remember that the load connected to the radio-controlled socket must
be configured first (see Section9.3, page79).
10 System Management
SMA Solar Technology AG
User Manual 95HoMan_Portal-BA-en-20
To Next Page
Loading...
