SMA sunny home manager - Activating;Deactivating Devices; Replacing the Sunny Home Manager

10.2 Activating/Deactivating Devices
In the following cases, you must deactivate devices in SunnyPortal:
• You have removed a device from your PV system
or
• You no longer wish to display a device in SunnyPortal
or
• You would like to replace the device in SunnyPortal by another device (see Section10.1,
page94).
The data of the deactivated device is retained in SunnyPortal.
Requirement:
• You must have the user role Installer or PV system administrator (see Section13.1,
page120).
Procedure:
1. Select the device properties of the device (see Section8.2, page66).
2. Select [Edit].
☑ The menu for setting the device properties opens.
3. To deactivate the device in SunnyPortal, deactivate the checkbox Active in the area Data
collection.
4. To activate the device in SunnyPortal, activate the checkbox Active in the area Data
collection.
5. Select [Save].
10.3 Replacing the SunnyHomeManager
Requirements:
☐ The NetID of the PV system must be set in the SunnyHomeManager (see the installation
manual of the SunnyHomeManager).
☐ The new SunnyHomeManager must be connected to the router (see the installation manual
of the SunnyHomeManager).
☐ The new SunnyHomeManager must be supplied with voltage (see the installation manual of
the SunnyHomeManager).
☐ You must be a system administrator (see Section13.1, page120).
Procedure:
1. Open www.SunnyPortal.com and select PV System Setup Assistant.
or
Go to www.SunnyPortal.com/Register.
☑ The PVSystem Setup Assistant opens.
10 System Management
SMA Solar Technology AG
User ManualHoMan_Portal-BA-en-2096