SMA sunny home manager - Reassigning the Sunny Home Manager to the Sunny Portal System after the Reset

2. Select [Next].
☑ The page User registration opens.
3. Activate the checkbox I am already registered in SunnyPortal.
4. Enter the e-mail address and the SunnyPortal password in the fields E-mail address and
Password.
5. Select [Next].
☑ The page Select PV system opens.
6. Activate the field Add or replace devices.
7. Select in the line of the SunnyHomeManager system for which you want to replace the
SunnyHomeManager.
8. Select [Next].
☑ The page Select devices opens.
9. Enter the serial number of the SunnyHomeManager in the field PIC. Enter the registration ID
of the SunnyHomeManager in the field RID.
10.
Reading off the serial number and registration ID
You can read off the serial number and the registration ID at the following locations:
• On the type label at the back of the SunnyHomeManager
• On the label included in the delivery
11. Select [Identify].
☑ SunnyPortal checks whether the serial number and registration ID correspond to the
connected SunnyHomeManager.
✖ The PVSystem Setup Assistant cannot find any SunnyHomeManager with the serial
number and registration ID?
An error has occurred.
• Eliminate the error (see Section15, page127).
12. Select [Next].
13. Select [Finish].
10.4 Reassigning the SunnyHomeManager to the
SunnyPortal System after the Reset
Once you have completely reset the SunnyHomeManager (see the installation manual of the
SunnyHomeManager), you must reassign the SunnyHomeManager to your
SunnyHomeManager system in SunnyPortal. Otherwise, SunnyPortal will not accept any data
from the SunnyHomeManager.
If you have reset the SunnyHomeManager and redetected the Plugwise radio-controlled sockets,
you must reestablish the connection to the Plugwise Stretch (see the SunnyHomeManager
installation manual).
10 System Management
SMA Solar Technology AG
User Manual 97HoMan_Portal-BA-en-20