SMA Sunny Island 2012 - 10.3 Making adjustments

SMA Solar Technology AG Operating the Sunny Island
Technical Description SI2012_2224-TEN082311 101
10.3 Making adjustments
10.3.1 Adjusting parameters
With the pushbutton on the Sunny Remote
Control 1 you can move through a menu and
select the desired parameter. When the
parameter appears on the display, you can read
the current value.
The parameter can be adjusted if there is an
"enter" arrow  to the right after the parameter
name.
1. Depress the knob.
2. The arrow skips behind the units and blinks.
3. Turn the pushbutton to the right or left. The
value increases or decreases.
4. When the desired value appears on the
display, save it. Press the pushbutton.
On the display appear "Ok? Y(es)/N(o)"
and the "enter" arrow.
5. Select Y or N. The letter selected blinks.
With "Y" you can confirm the parameter
change. With "N" you can discard the
change and the old value remains in
memory.
6. Press the pushbutton.
The parameter is set.
Adjusting parameters in standby
Note that some parameters can only be changed in standby mode. You can find the
parameters for which this applies in the tables in chapters 17.2 "Adjustable System
Parameters" (Page 166) and 17.5 "Functions During Operation" (Page 182).
222#02 ¿
AptTmBoost 
120 [Min]
222#02 ¿
AptTmBoost
120 [Min]
222#02 ¿
AptTmBoost
120 [Min]
Ok? Y/N 