SMA Sunny Island 2012 - Page 116

SMA Sunny Island 2012

212 pages

To Next Page

To Next Page

To Previous Page

To Previous Page

Loading...

Operating the Sunny Island SMA Solar Technology AG

116 SI2012_2224-TEN082311 Technical Description

Parameter settings

• Individual parameters and settings are retained during a firmware update.

• When updating, new parameters in the updated firmware are saved with the

factory default values automatically.

Table of Contents

Default Chapter3
- Table of Contents3
1 Notes on this Manual9
- Validity9
- Target Group10
- Storage of the Documentation10
- Explanation of the Symbols Used10
  - Syntax11
2 System Overview12
3 Safety Instructions16
4 Unpacking17
- Scope of Delivery18
- Sunny Island 2012/222418
- Sunny Remote Control 119
- Name Plate/Firmware Version20
- Sunny Island 2012/222420
- Sunny Remote Control 121
5 Installation22
- Required Tools and Resources22
- Sunny Island 2012/222423
- Dimensions23
- Choosing a Mounting Location24
- Observe Minimum Clearances25
- Mounting Position26
- Mounting the Sunny Island with a Wall Mounting Bracket27
- Sunny Remote Control 131
- Dimensions31
- Choosing a Mounting Location31
- Wall Mounting32
- Installing Batteries33
6 Opening and Closing36
- Opening the Sunny Island37
- Closing the Sunny Island38
7 Sunny Island Electrical Connection39
- At a Glance40
- DC Connection43
- Grounding43
- Connecting the Battery44
- Connecting the Sunny Island45
- AC Connection46
- Grounding47
- AC1 (Loads/Sunny Boys)48
- AC2 (Gen/Grid)50
- Sunny Remote Control 151
- Communication53
- Communication with Sunny Island53
- Communication with External Devices56
- Additional Connections59
- Battery Temperature Sensor59
- Battery Current Sensor61
- Multi-Function Relays 1 and 263
- Batvtgout Power Supply66
- Digin Digital Input66
- Configuring a System with Several Sunny Islands68
- Concluding Tasks69
8 Control Elements70
- Sunny Island70
- Control Panel on the Enclosure70
- Control Panel Buttons70
- Meaning of the Light-Emitting Diodes (Leds)70
- Sunny Remote Control 172
- Display Messages73
- Key73
- Rotating Pushbutton74
- MMC/SD Card74
9 First) Commissioning75
- Requirements75
- Starting the Quick Configuration Guide (QCG)76
- Commissioning the Battery Current Sensor81
10 Operating the Sunny Island83
- Switching on and off83
- Switching On/Starting83
- Stopping85
- Switching off87
- Disconnecting the Device from Voltage Sources87
- Restarting the System after Automatic Shutdown88
- Navigation Area89
- Standard View 192
- Standard View 293
- Select Menu97
- Selecting Parameters99
- Selecting Events99
- Selecting Warnings and Faults100
- Making Adjustments101
- Adjusting Parameters101
- Setting the Installer Password102
- Accessing Parameters Directly105
- Meter Compact105
- Saving Data Onto a MMC/SD Card107
- Inserting the Card111
- Removing the Card112
- Loading and Saving Parameters112
- Writing Log Data113
- Show Status113
- Updating Firmware114
11 Additional Functions117
- Load Shedding117
- Sleep Mode118
- Search Mode118
- Time-Controlled Operation119
- Overload and Short Circuit Behavior119
- Device Failure and Autostart119
12 Battery Management120
- Battery Temperature120
- Start Options121
- Charge State/Soc and SOH121
- Charge Control122
- Boost Charge124
- Full Charge124
- Equalization Charge126
- Manual Equalization Charge127
- Silent Mode127
- Battery Preservation Mode127
- Battery Diagnostics129
13 Connecting External Sources130
- Generator130
- Connecting Generator Connections in Parallel131
- Generator Start Options131
- Generator Operation135
- Manual Generator Operation135
- Automatic Generator Operation137
- Limits and Power Adjustment141
- Run Times143
- Operation Together with Sunny Boys144
- Stopping the Generator145
- Failures146
- Grid146
- Conditions147
- Stand-Alone Grid Operation147
- Grid Reconnection147
- Grid Operation148
- Grid Failure149
- Failures149
- Limits and Power Adjustment149
- Operation Together with Sunny Boys150
- Generator and Grid151
14 Relay152
15 Sunny Boy in the Island Grid System154
- Setting the Stand-Alone Grid Parameters154
- Frequency Shift Power Control (FSPC)156
16 Maintenance and Care158
- Enclosure158
- The Sunny Island's Control Panel158
- Sunny Remote Control 1158
- Functional Test158
- Battery159
- Disposal159
17 Parameter List Overview160
- Display Values162
- Adjustable System Parameters166
- Diagnosis178
- Events, Warnings and Failures (History)182
- Functions During Operation182
18 Troubleshooting/Problem Solving184
- Error Confirmation184
- Handling Autostart184
- Handling Failures Present During Startup184
- Display of Failures and Events184
- Events185
- Error Categories188
- Warnings and Failure Messages188
- Troubleshooting192
19 Optional Devices195
- External DC Fuse195
- External DC Charge Controllers (Optional)195
- Accessories (Optional)195
- SMA Products (Optional)196
20 Technical Data197
- Sunny Island 2012/2224197
- Sunny Remote Control 1200
21 Contact201
22 Glossary202

Related product manuals

Preview: SMA Sunny Island 5048

SMA Sunny Island 5048

Preview: SMA SUNNY ISLAND 6.0H

SMA SUNNY ISLAND 6.0H

Preview: SMA SUNNY ISLAND 3.0M

SMA SUNNY ISLAND 3.0M

Preview: SMA Sunny Island 4548-US

SMA Sunny Island 4548-US

Preview: SMA SUNNY ISLAND 6048-US

SMA SUNNY ISLAND 6048-US

Preview: SMA SUNNY BOY 3300

SMA SUNNY BOY 3300

Preview: SMA SUNNY BOY 5000

SMA SUNNY BOY 5000

Preview: SMA SUNNY BOY 2000HF

SMA SUNNY BOY 2000HF

Preview: SMA SUNNY BOY 5000TL

SMA SUNNY BOY 5000TL

Preview: SMA Sunny Boy 6000US

SMA Sunny Boy 6000US

Preview: SMA SUNNY BOY 3000TL

SMA SUNNY BOY 3000TL

Preview: SMA SUNNY BOY 1600TL

SMA SUNNY BOY 1600TL