Modes of behavior and safety precautions
l Electrostatic discharge from the fitter (e.g. due to brief contact with the vehicle body).
l Suitable clothing, e.g. made of cotton.
l Wear ESD safety shoes with conductive soles.
l Keep workplace clean, remove unnecessary objects such as common plastics.
l Special anti-static seat cushion protectors must be used when performing repair work inside a vehicle.
l Leave replacement parts in the original packaging for as long as possible, Do not cut open seals, but
cut open carefully.
l The ESD workplace must conform to the ESD guidelines. ESD protection
gotis://E 82 04.0
l Before unpacking, discharge ESD protective packaging at the ESD workplace.
l Avoidance of contact with electrostatic chargeable materials such as PE, PVC, styrofoam.
l Use only original packaging or specially labeled and defined packaging and transport materials.
l Electronic components which have been removed must be put down on an ESD workplace.
l Touch connectors on electronic components and in the wiring harness on the housing only. Do not
touch the pins and contacts!
l Electronic components must be installed before they are connected so that potential equalization with
the body can take place.
l Shelves and worktables must stand directly on the floor, there must not be any insulating materials
between the base of the shelves/feet and the floor. If the above mentioned insulators cannot be
removed, the shelves and work tables must be grounded (e.g. low-resistance electrical connection/line
from metal shelf to a heating pipe).
l Put down conductive transport container/box in a non insulated manner
(e.g. on a wooden pallet), otherwise no potential equalization takes place.
l Do not place control units and electronic components removed from the vehicle on electrostatically
chargeable materials, such as PE, PVC, styrofoam. The electrostatic charge is transferred to the
control unit or electronic component. An ESD service kit or a connected ESD table mat must be used.
Training
We strongly advise that each company should appoint a trained ESD officer in accordance with DIN EN
61340-5-1.
The ESD officer can hold employee training courses.
The objective of the training course measures is to familiarize the employees with the essential difficulties
and effects of ESD:
l Creation of discharging
l Reasoning behind safety precautions
l Effects and consequences of ESD
l ESD rules of conduct and safety precautions
2010 Smart Fortwo Passion
2009 ACCESSORIES & BODY, CAB Electrical System, Equipment & Instructions - Fortwo (Cabrio)
15 октября 2019 г. 19:12:10 Page 2 © 2011 Mitchell Repair Information Company, LLC.
To Next Page
Loading...
Need help?
General
