Contents
1 INTRODUCTION: page 2
2 HARDWARE DESCRIPTION: page 4
3 INSTALLATION: page 6
4 LED INDICATORS: page 16
APPENDIX A / B page 17
APPENDIX C page 18
APPENDIX D page 21
COYRIGHT & WARRANTY page 23
1 INTRODUCTION
Welcome
Thank you for choosing the Enhanced 10/100Base-TX to 100Base-FX
Media Converter. This device integrates copper and multi-mode/single
mode fiber networks in one flexible package.
Purpose
This guide discusses how to setup and install your Enhanced
10/100Base-TX to 100Base-FX Converter.
Terms/Usage
In this guide, the term "Converter" (first letter upper case) refers to
your Enhanced 10/100Base-TX to 100Base-FX Converter, and
"converter" (first letter lower case) refers to other converters.
Features
• Automatic MDI/MDI-X selection on RJ-45 port
• Link Fault Signaling (LFS)
• Store-and -forward at full wire speed
• Auto-negotiation, NWay support
• Half/Full duplex mode selection
• Remote and local loopback Test via DIP switch
• When DIP switches are set, the system auto-reboots to new
configurations without powering-off.
• Extends distance of up to 2km (6600 feet) multi-mode fiber and
60km (198000 feet) long-haul single mode fiber
• Compatible with other 10Base-T & 100Base-TX /FX devices
• LEDs for at-a-glance device status
• Suitable as stand-alone or in 19" 4/12-slot rack-mount converter
chassis or the single slot mini chassis (with internal power supply)
• FCC Class A & CE approved
English
English
1 2
To Next Page
Loading...
