SMC Networks SMC6750L2

SNMP C OMMANDS
3-43
SNMP Commands
Controls access to this switch from SNMP management stations, as well as
the error types sent to trap managers.
snmp-server community
Use this command to define the community access string for the Simple
Network Management Protocol. Use the no form to remove the specified
community string.
Syntax
snmp-server community string [ro|rw]
no snmp-server community string
• string - Community string that acts like a password and permits access
to the SNMP protocol. (Maximum length: 32 characters, case
sensitive; Maximum number of strings: 5)
• ro - Specifies read-only access. Authorized management stations are
only able to retrieve MIB objects.
• rw - Specifies read-write access. Authorized management stations
are able to both retrieve and modify MIB objects.
Command Function Mode Page
snmp-server
community
Sets up the community access string to
permit access to SNMP commands
GC 3-43
snmp-server contact Sets the system contact string GC 3-44
snmp-server location Sets the system location string GC 3-45
snmp-server host Specifies the recipient of an SNMP
notification operation
GC 3-45
snmp-server enable
traps
Enables the device to send SNMP traps or
inform requests (i.e., SNMP notifications)
GC 3-47
show snmp Displays the status of SNMP
communications
NE,
PE
3-48