Instructions for the User
25
10.5 Battery replacement (only on C9GGSSA model)
The appliance is equipped with a 9V battery to
light the gas burners even when there is a power
cut. When the battery runs out, it must be
replaced; if the battery is flat, no spark will be
provided to the igniters, making it impossible to
light the gas burners.
The battery is located in a special container in
the inside left-hand wall of the storage
compartment.
To replace the battery, its container C must be taken out of housing A in the storage compartment. Run
the head of a screwdriver B into opening D, press to the left and at the same time slide out the box
containing the battery E. Having replaced the battery, reinsert the container into its seat, making sure
that opening D is towards the inside of the storage compartment.
In order to reduce environmental pollution, you are advised to use rechargeable batteries.
To Next Page
