User instructions
22
• Do not use table salt as it contains insoluble substances which,
over time, may damage the water softening system.
• When necessary, refill the regenerating salt container before
starting the washing program. In this way, the excess saline
solution will be immediately removed by the water; the prolonged
presence of salt water inside the tank may lead to corrosion.
Be careful not to confuse the salt and detergent packages; adding
detergent to the salt container will damage the water softening system.
(Customizing the consumer parameters)
(available in all programs except the soak program)
The electronic control system allows personalizing the machine use
directly through a programming procedure not directly accessible that
allows: regulate water hardness level.
To access the programming environment, the
must
on with the door closed. Then proceed as follows:
• press the PROGRAM DELAY button until the H symbol
appears on the display, followed by the number currently set (e.g. H3)
• press the PROGRAM DELAY button the number of times
needed to select the right setting level for the hardness of the water
(H0, H1, H2, H3, H4, H5, H6);
N.B.: after few seconds the appliance exits the parameter setting menu
automatically.
To Next Page
Loading...
Need help?
General
