Smeg KITSPF-1 - User Manual

To Next Page

UNIVERSAL STACKING KIT

UNIVERSAL-STAPELSET

KIT DE SUPERPOSITION UNIVERSEL

UNIVERSELE STAPELKIT

UNIVERSAL SAMLESÆT TIL STABLING

YLEISVÄLISARJA

UNIVERSELT-STAPELKIT

UNIVERSELLT STAPELPAKET

KIT DE APILAMIENTO UNIVERSAL

KIT DE EMPILHAMENTO UNIVERSAL

STACKING KIT UNIVERSALE

UNIWERSALNY ZESTAW MONTAŻOWY

KIT UNIVERSAL PENTRU MONTARE

ΚΙΤ ΣΤΟΊΒΑΞΗΣ ΓΕΝΙΚΗΣ ΧΡΗΣΗΣ

UNIVERZÁLNÍ STOHOVACÍ SADA

UNIVERSALUS KROVIMO BLOKAS

UNIVERSĀLAIS STIPRINĀJUMA KOMPLEKTS

UNIVERZÁLNA STOHOVACIA SADA

Universal Stacking Kit Kurulum Kılavuzu

Universal Stacking Kit Instruction Booklet

Universal-Stapelset – Anleitung

Guide d’utilisation du kit de superposition universel

Instructieboekje Universele Stapelkit

Manual til universalt samlesæt til stabling

Yleisvälisarjan ohjekirja

Universel Stabelkit brugsanvisning

Universellt stapelpaket, instruktionsbroschyr

Folleto de instrucciones del kit de apilamiento universal

Manual de instruções do kit de empilhamento universal

Libretto di istruzione per stacking kit

Instrukcja użytkowania uniwersalnego zestawu montażowego

Broşură instrucţiuni kit universal pentru montare

Εγχειρίδιο Οδηγιών - Κιτ στοίβαξης γενικής χρήσης

Návod k montáži univerzální stohovací sady

Universalaus krovimo bloko instrukcija

Universālā stiprinājuma komplekta uzstādīšanas instrukcija

Návod na montáž univerzálnej stohovacej sady

Need help?

Do you have a question about the Smeg KITSPF-1 and is the answer not in the manual?

Summary

English

STEP 1: Place Retaining Ducts

Place the plastic retaining (1a-1b) parts on the Washing Machine as shown in the figure.

STEP 2: Attach Cosmetic Part

Attach the cosmetic appearance part (6) to the front face and connect to retaining ducts using screws.

STEP 3: Align Cosmetic Part

Align the cosmetic appearance part (6) to the cosmetically proper position with WM upper tray.

STEP 4: Place Rear Support Plate

Place the rear support plate (3) on the retaining duct (1) and adjust hole positions on the WM body.

STEP 5: Connect Retaining Duct

Connect the retaining duct (1a-1b) to WM body using self-tapping screws (5a) or butt-end torx screws (5b).

STEP 6: Place Tumble Dryer

Open Tumble Dryer feet and place it on the retaining duct (1) with two persons.

STEP 7: Move Tumble Dryer

Move the Tumble Dryer forward on retaining ducts (1) until feet are secured on the duct.

STEP 8: Remove TD Screws

Remove PT screws from the rearside body of the Tumble Dryer for later use.

STEP 9: Connect TD to Stacking Kit

Install the rear fixing part (4) to the retaining duct (1) part for TD connection.

STEP 10: Secure Rear Parts

Move rear fixing parts (4a-4b) and secure them to TD body using screws removed in step 8.

STEP 11: Complete Connections

Match holes between parts 1 and 3 and connect with plastic screws (2) to complete installation.