Cleaning and maintenance
52
3. Press the symbol to confirm. The
assisted cleaning cycle will start.
4. If the temperature inside the oven is too
high, a warning buzzer and message on
the display will instruct you to wait for it to
cool.
5. A buzzer will indicate the end of the
Vapour Clean cycle.
Setting programmed Vapour Clean
It is possible to program the Vapour Clean
start time, like any cooking function.
1. After selecting the Vapour Clean special
function, press the symbol .
2. Enter the time at which you require the
Vapour Clean function to end (for
example at 7:30 p.m. first touch the hours
box, then the numbers 1 and 9; touch the
minutes box, then the numbers 3 and 0).
3. Press the symbol to confirm.
4. The appliance waits until the set start time
to start the cleaning cycle.
To Next Page
Loading...
