CLEANING AND MAINTENANCE - 73914779617/C
Pyrolytic (on some models only)
Preliminary operations
Before starting the pyrolytic cycle:
• Clean the internal glass pane following the
usual cleaning instructions.
• Remove any food residues or large spills
from previous cooking operations from the
inside of the oven.
• Completely remove all accessories from
inside the oven.
• For very stubborn encrustations spray an
oven cleaning product onto the glass (read
the warnings on the product); leave for 60
minutes, then rinse and dry the glass using
kitchen roll or a microfibre cloth.
• If present, remove the temperature probe.
• Remove the rack/tray support frames.
• Close the door.
Pyrolytic function setting
1. Touch the OTHER FUNCTIONS
button on the “main menu”.
2. Scroll through the menu towards the left and
select the PYROLYTIC function.
3. Select the most appropriate setting for the
automatic cleaning of the oven cavity:
4. Touch the CONFIRM button to confirm
the setting.
The appliance is ready to start the automatic
cleaning cycle.
5. Touch the START button to start the
pyrolytic cycle.
During the pyrolytic function
• It is not possible to select any function once
the door lock device has been activated. It
remains possible, however, to switch off the
appliance using the specific controls.
• the fans produce a more intense level of
noise due to a greater rotation speed. This is
an absolutely normal operation, intended to
provide more effective heat dispersal.
• Two minutes after the pyrolytic cycle has
started, the door is locked by a device that
prevents the door from being opened (the
symbol appears on the display).
See General safety instructions.
Pyrolytic cleaning is an automatic high-
temperature cleaning procedure which
causes dirt to dissolve. This process
makes it possible to clean the inside of
the oven very easily.
Recommended pyrolytic cycle duration:
• Light dirt: 2:00
• Moderately dirty: 2:30
• Heavy dirt: 3:00
The PROGRAMMED COOKING
button can be used to set a
function delayed end time.
It is not possible to start the pyrolytic
cycle if the temperature probe is
plugged in.
The appliance will emit an error signal
each time the START button is
pressed.
During the first Pyrolytic cycle,
unpleasant odours may occur due to
the normal evaporation of oily
manufacturing substances. This is an
absolutely normal phenomenon which
disappears after the first pyrolytic cycle.
If the pyrolytic cycle gives unsatisfactory
results at minimum duration, it is
recommended to set a longer time for
subsequent cleaning cycles.
To Next Page
Loading...
Need help?
General
