Problem Possible cause Solution
The Super function is switched
on.
Refer to "Super function" section.
There is no cold air circulation in
the appliance.
Make sure that there is cold air
circulation in the appliance. Refer
to "Hints and tips" chapter.
Some specific surfaces inside the
fridge compartment are warmer
at some times.
This is a normal state.
Temperature setting LEDs flash
at the same time.
An error has occurred in measur‐
ing the temperature.
Contact the nearest Authorised
Service Centre. The cooling sys‐
tem will continue to keep food
products cold, but temperature
adjustment will not be possible.
If the advice does not lead to the
desired result, call the nearest Authorized
Service Centre.
8.2 Replacing the lamp
The appliance is equipped with a longlife LED
interior light.
Only service is allowed to replace the lighting
device. Contact your Authorised Service
Centre.
8.3 Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
installation instructions.
3. If necessary, replace the defective door
gaskets. Contact the Authorised Service
Centre.
ENGLISH 35
To Next Page
Loading...
