WWW.SMITTYBILT.COM
Installation Instructions
Scout Trailer Kit
Part#87400/87400-01
Parking cont.
• Always deploy stabilizer jacks before unhooking the trailer from the tow vehicle. Loads that have
shifted may change the balance of the trailer. Remember to always secure loads properly to prevent
shifting.
• Unhook trailer wiring from tow vehicle. The break away brake system uses power from the tow
vehicle to recharge the internal battery, if left hooked up it will draw current from the tow vehicle.
(dependent on tow vehicles trailer wiring setup) DO NOT use break away system battery to power
any other devices.
• When parking or storing your trailer, keep the coupler off the ground so dirt will not build up in the
hitch, ball socket or articulating hitch.
• After use in salt water environments, it is good practice to wash your trailer with fresh water as
soon as possible. If trailer is used in winter and is subjected to road chemicals used to melt snow,
wash with a mild detergent when you reach your destination.
6
To Next Page
Loading...