Save a recipe
After a program has been entered, the user can save this current program as a recipe for future use. Under the normal
operating mode, press and hold SET key for 2 seconds until the left window shows LCK. The right window will show 0. Use the
“+” or “-” key to adjust the value to “2” (the passcode for saving the program) and then press SET key to confirm. Then SAV
will be shown on the left window and End on right window.
If you press SET key now, you will exit this mode without overwriting any existing programs. Use “+” or “-” key to select the
name of recipe to which you want to store the program. If you press “+” (or “-” key) repeatedly, you will see “End”, “B1”, “B2”,
“C1”, “C2”, “F1”, “F2”, “P1”, “P2” one by one. Press the SET key again to store your current program under the selected recipe
name. This process will overwrite the current recipe data to the saved recipe data. Figure 9 shows the flow chart of how to
save a recipe.
Recall a recipe
To recall a recipe, press and hold SET key for 2 seconds until the left window shows LCK and then release the SET key. The
right window will show 0. Use + key to adjust the number to 1, and then press SET. “rC” (recall) will be shown on the left
window and End in the right window. This can prevent your current program being accidently overwritten by a recalled
program. Use “+” or “-” key to locate the recipe you want to recall. If you press “+” key repeatedly, you will see End, B1, B2,
C1, C2, F1, F2, P1, and P2 one by one. After you locate the recipe that you want to recall, press the SET key to select it. The
current program will be overwritten by the selected program. Figure 10 shows the flow chart of how to recall a recipe
Figure 9 flow chart of
saving a recipe
Figure 10 flow chart
of recalling a recipe
To Next Page
Loading...
Need help?
General