The SMS detector allows monitoring of five inputs and control of four outputs, one of which can be
controlled simply by ringing, and one which is controlled by the temperature sensor connected to the
Dallas bus.
1. List of accessories in the assembly
GSM antenna 3dB, SMA, magnet, 5m cable
Power adaptor 230V /10-14 VDC, 1,2A, na DIN (1.5 module)
Temperature sensor (-40 to 130°C)
2. Description of functions
GSM detector has five inputs, which are activated by
a positive impulse. When activated, it will send an
SMS to up to 4 telephone numbers, and ring 2
numbers.
Furthermore, the GSM detector has four outputs.
Outputs 1-4 are controlled by SMS. Output 1 is
controlled by the temperature sensor connected to
the bus Dallas. Output 4 (relay) is controlled by
calling the phone numbers of the SIM cards in GC
055. This option has up to ten phone numbers
entered in the phone book of GC 055. The unit will
reject the call to confirm reception of the command
and will connect the output for 2 seconds (the
connection time can be configured).
3. Configuration and inserting the SIM card
Configuration can be made from any mobile phone.
Configuration
SMS are sent to phone number of SIM card inserted
in the GC 055 unit. The unit will confirm launching the
command by sending an SMS message back to the
sender of command. Before inserting the SIM card,
disconnect the power to the GC 055 unit. Insert a
suitable tool (small screwdriver) into the notches on
the sides of the front panel to gently pry open the
cover. Open the SIM card holder using slight
pressure in the direction of the arrow (open). Place
the SIM into the open door of the holder so that the
notch on the SIM matches the recess in the base
holder. Close the SIM card holder and secure with
gentle pressure in the direction of the arrow (close).
The SIM card must not be blocked with a PIN or the account frozen by the provider. It must also
contain sufficient credit.
To Next Page
Need help?
General
