Instructions
DPLL
MIN ~ MAX
(A total of 15 kinds, the default is 7 kinds. The larger the number is, the stronger
the range to adapt to jitter, and the smaller the number, the better the performance
against clock jitter.)
This DPLL setting is a special function of ESS series products. It can adjust the
internal DPLL digital phase locked loop circuit Bandwidth, so that the chip
achieves a balance between anti clock jitter and input tolerance.
Its function:
When the clock stability of the input signal is good, this value can be reduced,
so that the clock performance of the system is better;
When the clock stability of the input signal is not good, the sound may be inter-
rupted. Increase this value can avoid the sound interruption! Especially when
using TV as signal source!
AUDIO PHASE
NORMAL (2+,3-)
INVERTED (2-,3+)
DIMMER
5 second ~ 60 second
(The range is 5 seconds-60 seconds. After setting, the screen will automatically
go off within this time, and the screen will re-light up if you operate the remote
control or the knob at any time.)
In this page, press and hold the button of the knob, the system will reset all
settings, including Bluetooth pairing status.
BRIGHTNESS
LEVEL 1 ~ LEVEL 6
RESET
To Previous Page
Loading...
