Assembly instructions
U
V
U
V
ƩĂĐŚŝŶŐƚŚĞƉĂŶĞůƐ
ϰƩĂĐŚƚŚĞůĂƚĞƌƉĂŶĞů;FͿĂŶĚfront
ƉĂŶĞů (D) to the metal stand (K) using4
pcs M6 x 25 screws (U) and 4
pcswashers (V).
^ĞĐƵƌŝŶŐƚŚĞƉrŽƉĂŶĞtĂŶŬ
5. Place propane gas tank (not included)
into the metal stand (K). Make sure the
gas tank sits on the metal stand
completely. Turn the preassembled wing
screw on the outer part of metal stand
(K) clockwise to secure the propane gas
F
D
K
Attaching the regulator
6. Turn the cylinder valve on the tank clockwise to
close the propane tank. Attach the preassembled
regulator from the table top (B) to the cylinder
valve by turning the regulator coupling nut
clockwise. Make sure it is fastened securely and
tighten connections by hand only. After
connecting, secure gas hose to the bracket on the
inside of the front panel .
CYLINDER VALVE
PRESSURE
RELIEF VALVE
BLEED-OFF
VALVE
REGULATOR
BLACK COUPLING NUT
turn clockwise to connect
turn clockwise
to reseal
8
To Next Page
Loading...