62
EEWB334A
M4x8 (4x)
iii-4
iii-6
4
3
iii-5
iii-7
1
2
Fitting and connecting the monitor
Fig. iii-4 VESA
support
The 4 screws needed (M4x8) to ! x the VESA support
to the monitor are part of the kit supplied.
— Fix the VESA support to the monitor.
Figure iii-5 Monitor Power Supply
— Fix the power supply to the back of the machine
using the Velcro strip provided.
Fig. iii-6 Connection of monitor and PC
Caution:
Before connecting the electronic cables turn off the
mains switch.
— Insert the monitor connector into the right socket
(2) of the embedded unit.
— Insert the connector USB (3) into the PC and the
monitor.
— Insert the monitor main connector (4) into the
socket.
— Plug in the plug (1, Fig.iii-5) of the power supply
cable.
Figure iii-7 Monitor Cables
— Fix the monitor cables to the supporting pole using
the clips supplied, leaving enough at the top to allow
the monitor to turn freely, as shown.
iv Test Procedures
• Balance a wheel to less than 0.25 oz (5 grams) per
plane.
• Perform a User Calibration. (F 6.2).
v Instructing the Operator
(Following applies only if a unit is installed by a service
Technician)
• Show and explain the Safety Booklet.
•
Show the operator how to switch the unit on and off.
•
Show the operator how to perform an emergency stop.
• Show the operator how to select a wheel type, enter
data and apply a weight.
To Next Page
Loading...
