Advanced Settings - MIG225Ai
Spot Welding Mode
1. Press and Hold until you see the Main Menu (Process Parameters)
2. Turn to scroll down to Spot and Click to select
3. Turn to highlight On or Off and Click to confirm selection
Spot Time
* The Length of Time for the spot weld
– Factory Preset at 1.0s
Pause Time
* The Off Time between each Spot Weld period when trigger is held down
– Factory Preset at OFF (0.0s)
Hot Start Assist (HSA)
* Start welding at a higher voltage to establish a strong initial bead on cold metal
* When Hot Start Assist is set to On, there will be Three Adjustable Parameters
S.C. Time (Start Current Time)
* The Length of Time welding at the Start Current percentage
– Factory Preset at 0.5s
Start Current
* The Percentage of the Welding Voltage the weld will begin at
– Factory Preset at 135%
Slope Time
* The Time of Change from the Start Current to 100% Voltage
– Factory Preset at 0.5s
Final Crater Filling (CRA)
* Fills the crater at the end of a weld by running at a lower voltage for a short time
* Final Crater Filling will occur after you release the torch trigger
* When Final Crater Filling is set to On, there will be Three Adjustable Parameters
Slope Time
* The Time of Change from 100% Voltage to Crater Current
– Factory Preset at 0.5s
Crater Current
* The Percentage of the Welding Voltage used to fill the crater
– Factory Preset at 60%
C.C. Time (Crater Current Time)
* The Length of Time welding at the Crater Current percentage
– Factory Preset at 0.5s
Please read the Owner’s Manual for more detailed instructions and advanced welding options.
To Next Page
Loading...
