Snapper 281023BVE (84871)

HARDWARE BAGS
Footnotes:
TP 400-5003-5-RE-N
Manual No. 7006152REAR ENGINE RIDER
SERIES 23
75
Part No Descri
p
tionItem Qt
y
Note
-- 7063039 1 HARDWARE BAG (Incl. the 17 items below) for manual start models
7011024 2 PLUG, 1/2” Cup Insert
7013321 2 BUSHING, Tie Rod
7013849 2 SPACER, .33 x .63 x .156
7013862 1 ROLL PIN, 1/4 x 1-1/2”
7023667 1 FOAM COVER, Steering Shaft
7023671 1 COVER, Steering Shaft
7090372 2 NUT, 1/4-20 Hex Center Lock, GR 5 or B
7091038 4 BOLT, 5/16-18 x 1/2” Hex Flange Nyloc
7091516 2 PIN, 5/32 x 1” Cotter
7090296 1 PIN, 3/16 x 1” Cotter
7090122 2 WASHER, 3/8” Flat SAE
7075018 2 BRACKET, Seat
7091714 4 BOLT, 5/16-18 x 1” Square Neck Carriage, GR 5
7023735 2 KNOB, Seat Adjusting, 5/16-18 thread
7011791 4 RETAINER, 5/16” Bolt
7023354 1 SWITCH, Seat (NC)
7090951 2 NUT, 5/16-18 Hex Large Flange Center Lock
-- 7061872 1 HARDWARE BAG (Includes the 15 items below)
7011024 2 PLUG, 1/2” Cup Insert
7013321 1 BUSHING, Tie Rod
7013849 2 SPACER, .33 x .63 x .156
7013862 1 ROLL PIN, 1/4 x 1-1/2”
7023667 1 FOAM COVER, Steering Shaft
7023671 1 COVER, Steering Shaft
7090372 2 NUT, 1/4-20 Hex Center Lock, GR 5 or B
7091038 2 BOLT, 5/16-18 x 1/2” Hex Flange Nyloc
7091516 2 PIN, 5/32 x 1” Cotter
7090296 1 PIN, 3/16 x 1” Cotter
7090122 1 WASHER, 3/8” Flat SAE
7090913 2 SCREW, #10-24 x 1/2” Hex Washer Self-Tap (Torx)
7023191 2 KNOB, Seat Adjusting (5/16-18 thread)
7028395 2 SPACER, Pivot
7029211 1 SEAT SWITCH, Quick Mount (NC)
-- 7063292 1 HARDWARE BAG (Incl. items 1-12 above & the 6 items below)
7023735 2 KNOB, Seat Adjusting, 5/16-18 thread
7023354 1 SWITCH, Seat (NC)