3
Uncrating
1. Using a reciprocating utility saw or equivalent, cut
crate away from bottom skid. Remove crate. Remove
plastic wrap.
2. Cut any banding securing the unit.
3. Locate literature pack, and identify contents:
• Operator’s Manuals and associated literature
• Set of Keys (in ‘Kids and Mowers Don’t Mix’
Blister Pak)
• Washout Port Connector (Note: On some units,
this may be attached to the washout port,
located on the left side of the mower deck.)
4. Using a hoist or similar lifting method, lift the machine,
remove the bottom skid from under it, and lower the
machine onto the ground.
IMPORTANT: To avoid damage, be sure to lift the
machine by the frame.
5. Set the ground speed control levers to START/PARK,
and engage the parking brake.
6. Make sure that the roll release rods (Figure 1),
located on either side of the engine, are pushed
down into the DRIVE position.
NOTICE
When cutting crate from bottom skid, use caution
around tires and mower rollers.
NOTICE
Do not tow rider. Towing the unit will cause transmission
damage. Do not use another vehicle to push or pull this
unit. Do not use this unit to push or pull another vehicle
or object.
285Z Series
Figure 1. Roll release rods
To Next Page
Loading...
Need help?
General
