Snell PS.10 - Connecting Two PS.10 s; Wiring Two PS.10 s using Line-Level Inputs; Wiring Two PS.10 s using Speaker-Level Inputs

10
CONNECTING TWO PS.10’s
You may wish to use two PS.10’s, particularly if you are in a large room.
fi Double subwoofers may be wired with either speaker-level or line-level connections.
fi Be sure the Phase Switch is set the same on both units.
Wiring two PS.10’s using speaker-level inputs
Use the ”OUT TO“ binding posts on one subwoofer to daisy chain to the second PS.10.
Wiring two PS.10’s using line-level inputs
Use "Y" connectors to daisy chain the ”PREAMP OUT“ signal to the input of a second PS.10.