• PORT: 587
• Mail Account: Create an email account with Gmail... that you want to send from (NB: keep it short there is limited space to enter!)
• Mail Password: Enter the password for the above email address that you created.
• NB: You have to set the security access to this email account on gmail to allow less secure devices to access this email account! This is in the
security setup of Gmail.
• FTP SETUP: CONFIRM IT IS “OFF” IF NOT SET TO “OFF” (DO NOT CHANGE ANY OTHER SETTINGS IN HERE)
• SEND TO:
PHONE: SELECT PHONE 1 AND ENTER NUMBER TO WHICH THE PHOTO MUST BE SENT (THIS IS ONLY IF YOU ARE USING MMS OPTION). YOU CAN ADD 2 NUMBERS IN
HERE. (NOTE: PLEASE ENTER NUMBER AS 082 000 0000 AND NOT AS +2782 000 0000) YOU WILL BE CHARGED PER NUMBER YOU SEND THE PHOTO TO.
EMAIL: ENTER YOUR EMAIL ADDRESS THAT YOU WANT TO RECEIVE THE PICTURE TO. (THIS IS FOR SMTP OPTION, EMAIL TO EMAIL)
• SENDING PIC SIZE: SELECT THE SIZE (THIS WILL ONLY BE APPLICABLE TO EMAIL TO EMAIL SENDING.
• MAX NUM/DAY: ENSURE THAT THIS OPTION IS SET TO “UNLIMITED” TO ENSURE THE CAMERA WILL SEND EVERY PICTURE TAKEN
• SMS CTRL: SELECT “BY TRIGGER” (THIS WILL GIVE YOU THE BEST BATTERY LIFE). IF YOU NEED SMS COMMANDS TO BE DONE IMMEDIATELY YOU CAN SELECT “ALL
THE TIME” (PLEASE TAKE NOTE: THAT YOU WILL ONLY HAVE BATTERY LIFE FOR A DAY OR TWO AS THE MODEM IS KEPT LIVE AND IS USING A LOT OF POWER)
• DAILY REPORT: SELECT “OFF”
(TO HIGHLIGHT THE 3G TO MOVE ACROSS TO OTHER COLUMN PRESS THE “M” BUTTON ONCE)
• LANGUAGE: USE ENGLISH
• DATE AND TIME: SET THE TIME AND DATE. (THIS WILL BE ON THE PHOTOS TAKEN)
• STAMP: SET TO “ON” (SO THAT THE PHOTO WILL HAVE A TIME AND DATE ON IT)
• BATTERY TYPE: VERY IMPORTANT TO SELECT THE TYPE OF BATTERY IF YOU WANT TO USE RECHARGEABLE AA BATERIES (DO NOT MIX ALKALINE AND
RECHARGEABLE BATTERIES)
• FREQUENCY: LEAVE ON “50HZ”
• SD CYCLE RECORDING: SELECT “ON” (THIS WILL DELETE THE OLDEST PHOTO AND KEEP THE NEWEST ONE ONCE THE SD CARD IS FULL ONLY)
• RESET: DO NOT DO ANYTHING IN HERE.
• PASSWORD: LEAVE THIS “OFF” (IF SELECTED “ON” AND YOU LOSE YOUR PASSWORD IT WILL BE BLOCKED)
• ABOUT: DO NOT DO ANYTHING IN HERE.
WHEN THIS SETUP IS DONE YOU CAN EXIT BY PRESSING THE “M” BUTTON ONCE.
THIS WILL TAKE THE LCD SCREEN BACK TO LET YOU VIEW WHAT THE CAMERA IS POINTING AT.
SWITCH OFF THE CAMERA USING THE “ON/OFF” BUTTON. (THIS WILL NOW SAVE THE CHANGES)
TO SWITCH ON THE CAMERA, YOU MUST FOLLOW THE FOLLOWING STEP BY STEP:
(PLEASE ENSURE THAT THE ANTENNA IS SCREWED ON AND THE BACKING OF THE CAMERA IS TIED TO WHERE YOU WANT THE CAMERA TO OPERATE)
• SWITCH “ON” THE GPRS SWITCH FIRST. (IF MMS OR EMAIL MUST BE SENT)
• SWITCH “ON” THE CAMERA AND CONNECT THE FRONT AND BACK UNITS TOGETHER AND SECURE THE CLIPS ON THE SIDE. ENSURE THAT YOU CAN SEE THE “RED LED” IN
THE FRONT FLASH 1-2 TIMES AFTER THE FRONT AND BACK PARTS ARE CLIPPED TOGETHER.
• THE CAMERA IS NOW ON AND READY TO TAKE THE FIRST PICTURE AND SEND THIS TO YOUR PHONE OR EMAIL AS YOU DID THE SETUP.
NOTE: LEAVE THE CAMERA ON FOR AT LEAST 15MIN TO DO A TEST ON THE FIRST PHOTO/EMAIL. IF YOU GET 2 OR MORE PHOTOS IN SHORTER TIME YOU CAN SWITCH
OFF THE CAMERA AND MOVE IT TO WHERE YOU WANT TO PUT THE CAMERA TO USE. (IF YOU ENABLED THE TIMER, PLEASE MAKE SURE WHAT TIME IT IS AND IT IS IN
YOUR WORKING TIME... OTHERWISE THE CAMERA WILL NOT WORK TILL YOUR SET TIME COMES)
PLEASE NOTE: THE CAMERA IS ONLY EFFECTIVE IF THE SIGNAL FROM CELL PHONE PROVIDER IS RELIABLE. THE CELL PHONE RECEPTION IN SOUTH AFRICA IS
INTERMITTENT AND THIS WILL AFFECT THE CONSISTENCY OF THE CAMERA. THE CAMERA CAN ONLY TRANSMIT A PICTURE IF THE NETWORK ALLOWS IT IN YOUR AREA.
INCONSISTENT PICTURE SENDING IS IN MOST CASES DUE TO THE NETWORK AND NOT THE CAMERA. THIS CAN BE TESTED BY TESTING THE CAMERA IN TOWN OR OTHER
AREA AND COMPARING THE RESULTS.
To Previous Page
Loading...