12
8. If Plow is equipped with auxiliary light kit, disconnect
wiring harness and coat terminals of wiring harness
plugs with dielectric grease.
Figure 1-6
9. Remove the two (2) lower, outboard Pivot Hitch Pins.
(See Figure 1-6)
10. Pull Snow plow assembly away from vehicle.
NOTE: To avoid corrosion during storage, coat the
exposed (chrome) portion of the lift and angle cylinders
with a light grease.
CAUTION
Never use pliers or any other tool to separate the
wiring harness connector halves.
LYNCH PIN
HITCH PIN
To Next Page
Loading...