Snom A190 - Pairing Headset with Handset; Pairing Process; Headset Operation Modes; Active Call Management

3
Pairing the headset with a handset
It is possible to pair the headset with a handset registered at the base station. The headset will get the
same extension number as the handset, and you can assign its former extension number to another
terminal.
1. On the extension page, click on the IPEI of the handset. The handset page opens.
2. From the drop-down box of Paired Terminal, select the terminal idx of the headset (Fig. 2).
Fig. 2
3. Click Save. The headset is now registered with the same extension number as the handset and can
also be used to call numbers dialed on the handset's keypad.
Fig. 3
Using the headset
• Turning headset on: press AUX and both VOLUME keys for 5 seconds or place
handset in charger.
• Turning headset o: press AUX and both VOLUME keys for 5 seconds.
Idle state
• Increase ringer volume: press VOLUME+ key .
• Decrease ringer volume: press VOLUME- key .
• Disable ringer audio (turn on silent mode): press VOLUME+ key for 2 seconds .
• Enable ringer audio (turn o silent mode): press VOLUME- key for 2 seconds .
• Enter voice prompt menu: press AUX key .
Active state
Ringing calls can be accepted on the handset or on the headset and then picked up on the other device.
• Accept/terminate call: press CALL key (1x) .
• Reject incoming call: press CALL key twice (2x) .
• Put call on hold/retrieve held call: press CALL key for 2 seconds .