4.
5.
6.
7.
a.
b.
c.
2.
3.
Make sure that all bases use the same and that the time server time server works correctly
It is also important that the DECT-dBm-level between repeater and base is not less than -75dBm
Whenever you need to re-configure a repeater or having problems re-connecting, you should it and try again.reset
Reset procedure
Plug out
Plug in for 1 to 5 seconds, then plug out
Plug in for 25 tot 35 seconds, then Plug out
Access code must be 0000 in order for a repeater to be able to connect. See also Why I'm not able to add a repeater to M300/M700 ?
Make sure you register the repeaters one by one
Related articles
Adding M5 repeaters in a multicell environment
Can I daisy-chain M5 DECT repeaters
DECT - 1. Multicell Deployment Guide
DECT - 2. Physical installation
DECT - 3.0 Multicell setup
DECT - 3.1 Add Extensions
DECT - 4. Site Survey
DECT - 5. Measuring with DECT Discovery Mode
DECT - 6. Best Practises
Do I need a management software for the M900 multi-cell?
How to auto upgrade firmware on M500, M55, M58
How to check which firmware version is currently installed on M500, M55, M58
How to make an Intercom call on M55, M58
How to manually upgrade firmware on M500, M55, M58
How to register an M5 repeater to a base station
How to reset an M5 DECT repeater
How to set up M500 in a dual-cell configuration
How to update M-Series - DECT handsets
How to update M300,M700,M900 DECT Base Station manually
M400
Further Information
VoIP Essentials
Visit the Snom Forum
Open a support ticket
Find a local partner
To Previous Page
Loading...