SNR S2940-8G-v2 Switch Configuration Guide
IPv6 Multicast Protocol
Multicast configuration:
Same as scenario 1
MLD Snooping interception results:
Same as scenario 1
41.2.4 MLD Snooping Troubleshooting
In configuring and using MLD Snooping, the MLD Snooping server may fail to run properly due to
physical connection failure, wrong configuration, etc. The user should ensure the following:
• Ensure the physical connection is correct
• Ensure the MLD Snooping is enabled under global mode (using ipv6 mld snooping)
• Ensure the MLD Snooping is configured on the vlan under global mode (using ipv6 mld
snooping vlan <vlan-id>)
• Ensure there is a vlan configured as a L2 general querier, or there is a static mrouter config-
ured in a segment,
• Use command to check if the MLD snooping information is correct
274
To Next Page
Loading...
General