Visualisation
Controller
ATyS
OPERATION
ATyS C40
60
SOCOMEC - Réf. : 532 929 B
Presentation
Operational modes
Programming
Operation
Visualisation
Automatic sequences
PRESENTATION
• This mode allows parameters to be displayed inde-
pendently from mode /AUT (if programmed on
input) switch position
• No code required to access parameters visualisation
• Without any action during 10 seconds on the keypad,
the LCD displays voltage available on active network.
Navigation in visualisation mode:
• Press “up” and “bottom” push buttons to access required parameter
• Press “left” and “right” push buttons to navigate in the different menus
To Next Page
Loading...
