socomec ATyS C55 - Timers, Alarms, and I;O Status

33
EN
ATySController C55/65 - 549866C - SOCOMEC
11.6. Timers
Allows the user to visualize the status of the timers.
RUN: Shows all the ongoing timers, and allows the user to bypass the timers
S1: Shows all timers linked to source 1
S2: Shows all timers linked to source 2
OPT: Shows all optional timers
The Bypass Timer option will allows user to Bypass the rst timer in the list with the use of a password (OPERATOR or above).
11.7. Alarms
Allows the user to visualize active and nalized alarms. It also has a shortcut by pressing OK to go to the Alarms menu and
clear alarms (password protected: operator).
ACT: Shows all active alarms, and allows the user to direct access to the alarm menu.
FIN: Shows all nalized alarms that are not acknowledged by the user.
In this screen, a direct access to the alarm log is available by pressing “down arrow” + “ok”, which will select the GO TO ALARM
(Requires password OPERATOR or above ) access in the left bottom of the screen. See more information about the alarm LOG
in chapter "Log Menu", page 41.
11.8. I/O
Allows the user to visualise the conguration of the I/O. The settings for the inputs and outputs on the controller will be shown
as well as the external I/O modules (if being used).
IN: Controller inputs.
OUT: Controller outputs.
E.IN: External inputs (IO10 modules).
E.OUT: External outputs (IO10 modules).