socomec ATyS C55 - OPERATION AND CONTROL; HMI and Menu Navigation

35
EN
ATySController C55/65 - 549866C - SOCOMEC
12. OPERATION AND CONTROL
12.1. HMI use
On the front face of the controller there are 14 keys/buttons that are used to congure, operate and visualise the ATS values
anytime.
Summary of the HMI buttons
Change dashboard / set
screen as favorite
LCD
display
Source and
switchsynoptic
Manual operation
buttons and
indicator
C65 programable LED
C55 LED COMM &
Inhibit
Automatic
button and LED
indicator
Test button and indicator
Lamp test
button
Power,
Fault and
alarm LED
Navigation
buttons
BUTTON OPERATION
Manual Turns on CTRL mode. Allows the use of the I, 0, II buttons that will send position orders to the switch.
Automatic
Turns on AUTO mode. Controller will automatically perform transfers in case of piority source unavailability and priority source
comeback.
I Position I (source 1) manual order. Only in CTRL mode.
0 Position 0 (center-off) manual order. Only in CTRL mode.
II Position II (source 2) manual order. Only in CTRL mode.
TEST Performs a TEST (as defined inside Parameters/Display/Options menu)
Arrows Navigation through different screens, menus, options and values.
Lamp Test/Fault
clear
Press: lamp test and information about LED on screen
Long press: Clear faults pop-up (only if faults active)
Back/Menu
Press: back/return to previous screen or clear pop-up
Long press: Back to Main Menu page
Dashboard/
Favourite
Press: Go to the favourite Dashboard / Change between dashboard type (1 to 8, in a loop)
Long press: Sets the current dashboard screen as favourite (C65 only)
OK/Save & Quit
Press: Enter / OK / set a value / accept / confirm
Long press: (only when configuring) Save and Quit (back to previous configuration screen)