socomec ATyS C55 - Statistics and Genset Scheduler

42
EN
ATySController C55/65 - 549866C - SOCOMEC
For each alarm, the following information will be shown:
• Type of alarm
• Status
• Starting time and date
• Duration of the alarm active (counter running for active alarms)
• Criticality of the alarm
To learn about alarm conguration and options (see "14.1.7. ALARMS parameters menu", page 63).
- FAULTS: 100 registers of faults and alarms can be stored inside the internal memory and they are divided into
“in progress” and “history”. Faults, however, permit also reseting faults using the option “ PRESS OK TO RESET
FAULTS” and conrming on the pop-up that appears on screen.
Faults, to the contrary of alarms, have no detail of each register. On the history log, the information is the fault description and
the time & date when it occurred.
13.3. Statistics menu
This menu details counters for:
• Cycles (operating hours, number of cycles, cycles in manu, cycles in auto)
• Operations (total and for each position)
• Running hours (total and partial) (partial can be reseted by user)
• Source 1 / Source 2 data (total time in source, partial time, last switch, total time on load)
• Genset 1 / Genset 2 data (total active time, total active time on load, genset start counter)
• Breaker : Number of trips and date of last trip