socomec ATyS C55 - I;O parameters menu

58
EN
ATySController C55/65 - 549866C - SOCOMEC
14.1.5. I/O parameters menu
All the I/O can be set on this menu. By default, the controller has 6 inputs and 6 outputs on the controller (called internal
Inputs / Outputs) and up to 6 optional I/O 10 modules with 4in/2out can be added (only C65) achieving up to 30 inputs and
18 outputs total. The I/O menu has the following submenus:
- INPUTS: permits conguring the 6 internal inputs
- OUTPUTS: permits conguring the 6 internal outputs
- EXTERNAL I/O DETECTION: permits detecting and autoconguring the external I/O modules. A Pop-up will signal the start
and end of the IO module detection, this detection can take a few minutes to complete.
- EXTERNAL I/O CONFIG: permits conguring each one of the external modules. The way to identify the modules is thanks to
the module ID, written on the module and unique for each one of them. The conguration procedure is the same than with
the internal I/Os
Note: the specic functions that are related to the I/O might require some settings to be congured on the
SPECIFIC FUNCTIONS menu. Consult the I/O Annex 15 - 3, page 91 and Annex 15 - 4, page 94 to have the
full list of functions to be congured on the I/O.
Warning after each menu conguration do not forget to save by pressing "SAVE CONFIG" or pressing the "OK"
button for at least 1.5 seconds.