20
EN
ATYS D10 / D20 - 542359B - SOCOMEC
9. ATyS D20 visualization
It is possible to display controlled parameters in both automatic and manual modes (but not during program-ming).
No code is required to perform visualization.
Permutation cycles have priority over visualisation and display timer countdown during cycle operation.
Without keypad activation or any operational sequence during 5 minutes, the LCD returns to default display mode
and switches off the backlight.
>
If both sources are available :
• One visualisation screen is split into 2 parts and
displays simultaneously voltage and frequency values
on both networks.
• If a timer is active on one of the sources, its count-
down is displayed instead of voltage and frequency
values.
Examples:
>
If only one source is present:
• During permutation cycle, voltage and frequency
values of the available source (active) are displayed on
2 lines. The name of the active timer and its countdown
are displayed on remaining 2 lines.
• Out of a permutation cycle, phase to phase voltages
and frequency are displayed.
Examples:
Press "left", "right", "top" & "bottom" push buttons to access available screen
Press "navigation" push button to navigate in visualisation, displaying all available screens.
Architecture of visualization menu
To Next Page
Loading...
