5
EN
ATYS D10 / D20 - 542359B - SOCOMEC
4. Operation
4.1. ATyS D10 display
The ATyS D10 allows remote display of the transfer switch: positions, source availability and operational modes.
Programming and operation remains available directly on the master product ATyS C30, ATyS M6e, ATyS d, ATyS t
and ATyS g
(Compatible with the old ATyS range 6e and ATyS 6m).
Source 1 available Power on
• ATyS product fault, non-conform
switching
• Possible to reset after fault is cleared.
Switch off the power supplies of the
master product for 3 minutes.
Transfer switch in
position I
Transfer switch
in automatic mode
Transfer switch in
position 0
Transfer switch in
position II
Source II available
To Next Page
Loading...
