socomec ATyS g M - Three Phase Dimensions; Back Plate Mounted Three Phase; DIN Rail Mounting

ATySgM - 542933D - SOCOMEC
22 EN
9. INSTALLATION OF OPTIONAL ACCESSORIES
9.1. Auxilliary contacts
Ref. 13091001 or ref. 13091011.
To t an additional AC, the switch must rst be put in the 0 position. An auxiliary contact module comprises: one NO/NC
or NOC changeover contact for each position (I-0-II). To install use the screws supplied with the module.
One module is factory tted.
10 mm
0,5 to 2.5 mm²
solid
stranded
0,5 to 1.5 mm²
PUSH-IN
Use 20mm
screws for
1 module
Use 35mm
screws for
2 modules
Posidriv PZ2
1 Nm
9.2. Voltage sensing and power supply tap
Ref. 1399 4006.
This provides 2 connection terminals for conductors with cross-section ≤1.5 mm².
The single pole terminals can be tted in any of the terminal cages without reducing the cage connection capacity.
2 parts/ref. Do not use in case of use of the bridging bar.
6 mm
Slotted head 3,5 mm
0,45 Nm
0,5 to 2,5 mm²
0,5 to 1,5 mm²
9.3. Bridging bars 2P
Ratings ≤ 125A: ref. 1309 2006; 160A : ref.1309 2016
10 to
70 mm²
15mm
Hexagonal Metric
Allen size 4
5,0 Nm
Bridging bar.
125A: 1309 2006
160A: 1309 2016
OKOK
OKOK
Allen size 4
Hexagonal Metric
44.1 lb-in 5,0 Nm
15 mm / 0,59 "
# 8 to # 00 AWG
10 to 70 mm
2
10 to 70 mm
2
*
# 8 to # 00 AWG
!
X4
OKOK
OKOK
Allen size 4
Hexagonal Metric
44.1 lb-in 5,0 Nm
15 mm / 0,59 "
# 8 to # 00 AWG
10 to 70 mm
2
10 to 70 mm
2
*
# 8 to # 00 AWG
!
X4
2 4 6
8
1
3
5 7
2 4 6 8
1 3 5 7
/
317 315 314 313 201202 102 101
2 4 6
8
1
3
5 7
2 4 6 8
1 3 5 7
/
317 315 314 313 201202 102 101
OK NOK
Source II
LOAD
Make sure that the bridging bar is tted to the correct set of terminals.
There are two references available: one for ratings up to 125A, and another for 160A rating.