socomec ATyS g M - Three Phase Version Programming

ATySgM - 542933D - SOCOMEC
39EN
13.4.3. Sealable conguration cover
Conguration settings may be protected by means of a sealable cover.
Refer to section «4. Optional accessories», page 17.
13.5. Automatic mode
Close the cover to enter automatic mode. Make sure that the changeover switch is in automatic mode (AUT LED lit).
13.5.1. Sealable Auto/Manual cover
Auto/Manu mode can be protected by sealing the standard Auto/Manu cover as shown.
13.6. Possible actions
Once in automatic mode, it is possible to:
• Activates on load test
• Run a source
I
or source loss sequence
II
,
• start a restoration sequence source
I
or source
II
.
Test on load
Source
I
return:
source
II
Loss of source
I
/
source
II
AUTOMATIC MODE