socomec ATyS M 6e - Installation and Commissioning: Control, Power Supply, and Operation Modes; Control;Command Terminals (STEP 3 B); Power Supply Terminal Connection (STEP 4); Check Procedure (STEP 5)

9
EN

Whilst in manual mode, check the wiring
and if ok power up the product.
LED “Power” Green: ON

Available): ON
W
a
STEP 5
Check
Ensure that the emergency handle is
not inserted in the product and turn
the mode selector to the AUT position.
LED “Power” Green: ON
LED Manuel/Default: OFF
___________________________________________________________
Ensure that the emergen
STEP 6A
Motorised Operation
To enable control, close contact 312 with 317.
To force the product to 0 position/OFF bridge
the contact 313 with 317.
For contactor logic bridge contact 316 with 317.
To operate: close the contact corresponding to
the desired position.
 maintened
order I
position I
order 0
position 0
order II
position II
Contactor logicImpulse logic
STEP 6C
Padlocking Mode
(in position O)
3x
Ø 4-8 mm
Ø
0.15-0.31 in
CONTROL / COMMAND Terminals - Ensure that the product is in Manual Mode.
C
STEP 3B
STEP 4
Power Supply Terminal - Remove the Top cover to access and connect the terminal - Replace the cover before putting in service.
1
2
3
Connect the product with a cable of section of 24 to 16 AWG.
Screw M3 - Tightening torque: min.: 5 lb-in - max. 7 lb-in.
1
2
301 3022
312 313 314 315 316 317 63A 64A 24 14 04 13
1
2
Class CC
4A fuse
Spares: Motorisation module
AUT
AU
U
AUT
90°
90°
III
0
0
STEP 6B
Emergency Manual Operation
AUT
AU
U
AUT
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
AUT
Ref. Spare part motorisation
USED FOR ATyS REFERENCE
97095010 100A 2, 3, 4 P
B4
97232010 / 97233010 / 97234010
97095020 200A 2, 3, 4 P 97232020 / 97233020 / 97234020
97095026 260A 2, 3, 4 P
B5
97232026 / 97233026 / 97234026
97095040 400A 2, 3, 4 P 97232040 / 97233040 / 97234040
NOTE: Nominal Aux. Supply Voltage : 208 – 277Vac