socomec ATyS s - Putting the Atys P into Auto Operation


EN
ATYSp - 542001E - SOCOMEC
15. PUTTING THE ATYSPINTOAUTOOPERATION
After all checks have been veried and all programming and commissioning procedures are ready and ok, once
ready to put the ATySp into AUTO operation, turn the mode selector switch from Manual to Auto.
Note: When the product is powered and properly congured, when switching the product from Manual Mode to AUT the POWER
and READY LED’s should be a steady Green light.
WARNING
Depending on the state of the ATySp the ATS automation may change the switch
position as soon as the mode selector is switched to AUT. This is a normal operation.